livingnote

Re: Crush N Blend Rev 6 (CNB / Wet-Dry Circuit) + Support
« Reply #60 on: April 05, 2019, 05:30:19 AM »
Working on a new SMD version here :)



In this version, I opted to go with these more simple Bourns Trimmers with J-Hooks:



But what's handy is that there is exactly enough space there to also go with some multi-turn
trimmers like the Vishay T63-YA in case you want more precision and less drift over time.
« Last Edit: April 28, 2019, 10:23:22 AM by livingnote »
Quote from: emrr
F-in' hook some Sh*t up and see if it catches on fire

My Stuff: Livingnote's META


livingnote

Re: Crush N Blend Rev 6 V3 (CNB / Wet-Dry Circuit) + Support
« Reply #61 on: April 28, 2019, 10:07:58 AM »


Quote from: emrr
F-in' hook some Sh*t up and see if it catches on fire

My Stuff: Livingnote's META

Re: Crush N Blend Rev 6 V3 (CNB / Wet-Dry Circuit) + Support
« Reply #62 on: July 18, 2019, 11:09:26 AM »
I sent you a pm for an order

Re: Crush N Blend Rev 6 V3 (CNB / Wet-Dry Circuit) + Support
« Reply #63 on: November 22, 2019, 05:50:05 PM »
It's been more than 120 days, is this board still available?
Livingnote pm box is full.

If anyone is still visiting, does anyone know of a wet dry solution for thee gssl?

Thanks!

Rocinante

Re: Crush N Blend Rev 6 V3 (CNB / Wet-Dry Circuit) + Support
« Reply #64 on: December 17, 2019, 12:30:14 PM »
The trimpot value is 50k?
Schematic doesn't show value. So could one use a 47k fixed resistor?
If there's a harder way to do this, I haven't found it yet.


 

Related Topics

  Subject / Started by Replies Last post
10 Replies
5248 Views
Last post June 15, 2005, 04:00:30 AM
by gyraf
46 Replies
22854 Views
Last post April 28, 2014, 09:48:49 AM
by MaNiAC
10 Replies
5049 Views
Last post February 17, 2016, 11:02:44 AM
by livingnote
7 Replies
3452 Views
Last post August 27, 2010, 08:23:15 AM
by earthsled