Got on well with it today.
The main part of the chassis is finished and major parts fitted.
I made the RH side panel to keep it all rigid and attached the left side of the power supply section.
All the tubes seem to fit in OK along with some 15k:600 OPT's.
There are three sections on that chassis, regulated power supply, Compressor amp and feed forward side chain amp.
Next job is to sort out the earth busbar and the the tube heater supplies. I will then be able to run the heater supply to the tubes and determine the value of the Al clad dropper resistor. This has to be fitted before I can fit the rest of the power supply together.
All for now
DaveP
The main part of the chassis is finished and major parts fitted.
I made the RH side panel to keep it all rigid and attached the left side of the power supply section.
All the tubes seem to fit in OK along with some 15k:600 OPT's.
There are three sections on that chassis, regulated power supply, Compressor amp and feed forward side chain amp.
Next job is to sort out the earth busbar and the the tube heater supplies. I will then be able to run the heater supply to the tubes and determine the value of the Al clad dropper resistor. This has to be fitted before I can fit the rest of the power supply together.
All for now
DaveP