innercityman
Well-known member
Hi everyone,
Hi everyone, as mentioned on the title, I would like to wire the turbo board and make it work permanently but as the kit I bought from Gustav have an HPF function switching on & off, I would like to retain this function. I can't find any thread talking about this.
So my first question is: is it possible ? and if yes, how to wire it ?
This is my first built and for now the GSSL works nicely.
Thanks for your advices !
UPDATE DECEMBER 27/2016
To explain the problem I got...I installed a turbo board on my GSSL and everything seemed to work fine until I realized that something was going wrong. My GSSL is inserted on the main mix buss of my analog console and it seems to work ok as I got a compressed signal on both my left and right monitors, but when muting right side of my stereo mix, left side signal is not compressed and the needle of the GSSL vu meter stays at 0. When muting left side, right side signal is compressed, so left side signal, the one that is sent to the turbo board seems to not go into the side chain, but as I said, I have both sides compressed when sending a stereo signal. Any advices???
Hi everyone, as mentioned on the title, I would like to wire the turbo board and make it work permanently but as the kit I bought from Gustav have an HPF function switching on & off, I would like to retain this function. I can't find any thread talking about this.
So my first question is: is it possible ? and if yes, how to wire it ?
This is my first built and for now the GSSL works nicely.
Thanks for your advices !
UPDATE DECEMBER 27/2016
To explain the problem I got...I installed a turbo board on my GSSL and everything seemed to work fine until I realized that something was going wrong. My GSSL is inserted on the main mix buss of my analog console and it seems to work ok as I got a compressed signal on both my left and right monitors, but when muting right side of my stereo mix, left side signal is not compressed and the needle of the GSSL vu meter stays at 0. When muting left side, right side signal is compressed, so left side signal, the one that is sent to the turbo board seems to not go into the side chain, but as I said, I have both sides compressed when sending a stereo signal. Any advices???