anyone familiar with a DC300 original

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

pucho812

Well-known member
Joined
Oct 4, 2004
Messages
15,013
Location
third stone from the sun
looking at a DC300.  I have a working channel, but channel 2 has no output and blows the fuse for the DC(+) on  channel 2.

sifting through the manual and hard to find an original dc300 schematic.

IF anyone has one,  would it be possible to get a copy...

fuse for DC(+)  on the channel 2 side pops... so must be a shorted transistor but not sure where yet.
 
Pucho

There are a few repair and upgrade articles on the web, mainly for the 300a and 300II. From memory, one of the recommendations is to swap out the ceramics and put in some npo/cog types.

Or even poly caps.

I have a 300  mkIi in my storage rondavel (hut) for a rainy day project........

Peter

 
output transistors were replaced due to  failing testing. Unit still  blew  the d.c.(+)  fuse after replacing the failed output transistors.  However those output transistors can cause problems for components further up the chain so time to focus there.
 

Latest posts

Back
Top