metalb00b00
Well-known member
- Joined
- Jul 8, 2012
- Messages
- 294
Last time I ordered 10 pcs for $10 with them, everything went smooth. Did two boards instead of one, because of through hole parts, and no space left.
Revised my design to use SMD parts to fit everything on the same board, and kept the size the same as the old one.
First submission I was charged $50.
Re-submitted the files, and wrote down "NO PANELIZATION REQUIRED."
Today it became $25, instead of $10.
Apparently, there's a hidden cost of $15 to print my manual cutting guidelines that I drawn on the top silkscreen of my boards.
Revised my design to use SMD parts to fit everything on the same board, and kept the size the same as the old one.
First submission I was charged $50.
Re-submitted the files, and wrote down "NO PANELIZATION REQUIRED."
Today it became $25, instead of $10.
Apparently, there's a hidden cost of $15 to print my manual cutting guidelines that I drawn on the top silkscreen of my boards.