Is there a standard for the thickness of a front panel depending on size? I know thicker is usually better in terms of rigidity but I'm debating between 3mm and 2.5mm at front panel express. It's a 3RU panel so I'm worried about too much flexing. I'm also considering the cost and the 6.5 mm bushing length on the alpha pots I'm using. I think 3 is about as thick as I can go unless I add a cavity on the rear of the panel which increases the cost. But if its going to flex then it might be worth it.
What do you guys think?
I've attached a pdf of the panel layout. The shaded area are knobs and meter bezels btw.
Thanks!
What do you guys think?
I've attached a pdf of the panel layout. The shaded area are knobs and meter bezels btw.
Thanks!