dukasound
Well-known member
Hi Langevinians :sam:
Langevin is on my bench :grin:
After about three months I received AM16 :grin:
I resoldered a couple of wires and IT WORKS. All parts are original. Transistor Q1-Q6 are 2N5210 and I suppose Q7 and Q8 are 2N3053. Both input and output transformers I connected to 600ohm. Now I use «Low Power»..
On PSU I saw 24,3VDC. Checked voltages who is higher than in manual (maybe with «High Power» will be lower).
Then I adjusted balance. Because I havent distortion meter I check with simple method. I adjust trimmer for zero voltage beetween emiters of Q5 and Q6.
A little crash on AM16 face :sad:
Also I make and chech a Joe' input pad. It works very good.
Sound is nice and FAT. I compare AM16 and my dbx286A (bypass compressor,etc) and it sounds much better.
Thanks to my best man Mickey from Chicago who bought this for me and Joe for suggestions about input pad and other dilemmas.
Duka
Langevin is on my bench :grin:
After about three months I received AM16 :grin:
I resoldered a couple of wires and IT WORKS. All parts are original. Transistor Q1-Q6 are 2N5210 and I suppose Q7 and Q8 are 2N3053. Both input and output transformers I connected to 600ohm. Now I use «Low Power»..
On PSU I saw 24,3VDC. Checked voltages who is higher than in manual (maybe with «High Power» will be lower).
Then I adjusted balance. Because I havent distortion meter I check with simple method. I adjust trimmer for zero voltage beetween emiters of Q5 and Q6.
A little crash on AM16 face :sad:
Also I make and chech a Joe' input pad. It works very good.
Sound is nice and FAT. I compare AM16 and my dbx286A (bypass compressor,etc) and it sounds much better.
Thanks to my best man Mickey from Chicago who bought this for me and Joe for suggestions about input pad and other dilemmas.
Duka