Michaelsmith1160
New member
- Joined
- Jul 28, 2017
- Messages
- 2
Hey, I'm building the SK573 mic pre and ran into a snag...
Step 44 in the doc: http://www.soundskulptor.com/docs/mp573-assembly-guide-02.pdf
States that the PCB is tooled for "2 pinouts" for the transistor, or 4 holes for a 3 pin device. It states to use the "a" position of "a" or "b". The image makes it look like only two legs of the transistor are used, which can't be true. Anyone know what this means or how I should proceed?
Thanks!
Michael Smith
Step 44 in the doc: http://www.soundskulptor.com/docs/mp573-assembly-guide-02.pdf
States that the PCB is tooled for "2 pinouts" for the transistor, or 4 holes for a 3 pin device. It states to use the "a" position of "a" or "b". The image makes it look like only two legs of the transistor are used, which can't be true. Anyone know what this means or how I should proceed?
Thanks!
Michael Smith