Neve BA283AM questions(s)

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
The trick with 183/283's is not to bias them in a module, since there is often gain boosting going on.
If you have just the board in a test jig, or a clone board without external gain boost,
just trim for maximum level where at the onset of clipping, the clipping is the same top and bottom.
This will probably come in around +27.5 ish. Then you can check that you have 80mA of current draw,
so that confirms the 183 as good.
 
Back
Top