Am I right that when the level measurement unit is set to voltage it gives a peak value as opposed to a peak to peak value?
The AP agrees with its self and my other volt meters using dBu on the AP and converting to RMS voltage. When displayed on a scope it takes up double the vertical division setting than it should. A 1V signal takes 2 vertical divisions when vertical is set to 1V/div
I was looking at the AP and noticed the voltage is displayed with a “-p” not a “p-p”. I’ve never seen voltage displayed as peak value as opposed to peak to peak. I couldn’t find anything in the manual.
The AP agrees with its self and my other volt meters using dBu on the AP and converting to RMS voltage. When displayed on a scope it takes up double the vertical division setting than it should. A 1V signal takes 2 vertical divisions when vertical is set to 1V/div
I was looking at the AP and noticed the voltage is displayed with a “-p” not a “p-p”. I’ve never seen voltage displayed as peak value as opposed to peak to peak. I couldn’t find anything in the manual.