JAY X

Check this patch wiring
« on: November 04, 2018, 06:30:16 AM »
Hi!

I want to make sure the wiring of the patchbay schematic is correct.

It shows daw outputs 1-2 normalled to the summing inputs 1-2. Ok so far, but if i want to place a processor between the daw outputs and summing inputs i have to break the normalling connections... I think it is right, but i am not sure...

Thanks for your comments!

Jay x


moamps

Re: Check this patch wiring
« Reply #1 on: November 04, 2018, 01:11:05 PM »
It's ok. You can place also comp inputs below outputs and use isolated setting in the patchbay. That way you will save two columns.

JAY X

Re: Check this patch wiring
« Reply #2 on: November 05, 2018, 04:07:01 AM »
Hi Moamps!

Ok!. And the isolating setting is a great solution!

Thanks a lot! :)

Jay x


 

Related Topics

  Subject / Started by Replies Last post
3 Replies
1268 Views
Last post December 14, 2004, 03:24:00 PM
by Kev
6 Replies
3517 Views
Last post May 30, 2009, 09:20:59 AM
by okgb
7 Replies
2685 Views
Last post March 30, 2011, 05:38:33 PM
by SSLtech
2 Replies
351 Views
Last post October 13, 2018, 04:33:08 AM
by masteringpole