madswitcher

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #20 on: January 05, 2019, 06:53:58 PM »
Very much thanks for post  !  :)

I would like to have a real hard box (no plug in) with that  in-out stages , and insert point as well  :)

started the request discussion after a successless check around
about  related serious  diy kit  or step by step rev. eng.
(considered what made for less important devices , transformers rev. eng. included...)

seem there is not interest about ….  :'(

Adre and I have explained how you can construct a hardware unit with a 'Studer' flavour if you want - its up to you to do the research and DIY to build one.  But as Abbey has said, Studer's electronics are renown for being faithful to their source when used within their limits.

Regards

Mike


SIXTYNINER

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #21 on: January 06, 2019, 12:09:31 PM »
Adre and I have explained how you can construct a hardware unit with a 'Studer' flavour if you want - its up to you to do the research and DIY to build one.  But as Abbey has said, Studer's electronics are renown for being faithful to their source when used within their limits.

Regards

Mike

And i very much thank you  about ,
the most useful post of the thread , till now…

perfectly in tune with the concept on which this forum was founded ….
and the diffusion deriving from it ,

unfortunately what many do not understand , or feign not to understand
(only for personal interests…)

and again , i started the thread only because nothing about i found around…

more thanks
cheers

>>" 1 Picture say what billions words cannot "<< - >>"SMD Kill the DIY STAR"<<
Why in the  forum  if no share

abbey road d enfer

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #22 on: January 06, 2019, 12:53:13 PM »
the most useful post of the thread , till now…
Quite an ungrateful comment.

Quote
unfortunately what many do not understand , or feign not to understand
I think most of the answers were substantiated enough, but you reject them because they are not in agreement with your preconceived ideas.

Quote
(only for personal interests…)
That is quite insulting. I have nothing to sell, nothing to gain.

Quote
and again , i started the thread only because nothing about i found around…
Could be there's a good reason for that...
Who's right or wrong is irrelevant. What matters is what's right or wrong.
Star ground is for electricians.

SIXTYNINER

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #23 on: January 07, 2019, 05:18:47 AM »
Quite an ungrateful comment.

I think most of the answers were substantiated enough, but you reject them because they are not in agreement with your preconceived ideas.

That is quite insulting. I have nothing to sell, nothing to gain.
 Could be there's a good reason for that...

it is all related generically, and to those who are related, not individually,

maybe it's not that : asking is legal,
and responding (in a contributory way) is courtesy ?  (always if desired)

…. to argue apart ,
any post about thread title is welcome ,
cheers

PS:
do not kidding ,
supporting that here there are not  those who  "grab" only  for money...
« Last Edit: January 07, 2019, 11:01:23 AM by SIXTYNINER »
>>" 1 Picture say what billions words cannot "<< - >>"SMD Kill the DIY STAR"<<
Why in the  forum  if no share

SIXTYNINER

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #24 on: January 08, 2019, 09:12:45 AM »
……..an A80 tape machine……
The circuit diagram can be found on the Studer FTP document site.

Regards

Mike

checked studer ftp but seem not work…
or my browser have issue…

cheers
>>" 1 Picture say what billions words cannot "<< - >>"SMD Kill the DIY STAR"<<
Why in the  forum  if no share

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #25 on: January 08, 2019, 10:18:12 AM »
checked studer ftp but seem not work…
or my browser have issue…

cheers

Studer FTP is down since weeks for me too, not sure it's an browser issue...hope it's a momentary issue and not a policy change from Studer/harman  :-X

Best

PRR

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #26 on: January 08, 2019, 11:56:27 PM »
> Studer FTP is down

Try pirate site:   
https://www.reeltoreel.nl/studer/Public/

SIXTYNINER

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #27 on: January 09, 2019, 04:01:20 AM »
> Studer FTP is down

Try pirate site:   
https://www.reeltoreel.nl/studer/Public/

PRR  , Magic Man Of GroupDIY !!

much thanks and cheers  :D

Studer FTP is down since weeks for me too, not sure it's an browser issue...hope it's a momentary issue and not a policy change from Studer/harman  :-X
Best

….As Jakob say..
keep safe distance from….

or you can be sucked to black hole …
…unfortunately  :(
« Last Edit: January 09, 2019, 07:37:15 AM by SIXTYNINER »
>>" 1 Picture say what billions words cannot "<< - >>"SMD Kill the DIY STAR"<<
Why in the  forum  if no share

PRR

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #28 on: January 09, 2019, 11:40:43 AM »
> Magic Man Of GroupDIY !!

Just Google "Studer FTP". No magic needed.

madswitcher

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #29 on: January 09, 2019, 12:53:52 PM »
Hi again,

To save you some time, the line driver card I was referring to can be found in the A80  Mk 1 Service manual

https://www.reeltoreel.nl/studer/Public/Products/Recording_Analog/A80VU_MkI/Manuals/A80VU_MkI_Serv.pdf

 on page 228.  The op amp I was referring to is denoted as A101 and the gain is about 24dB and not 34dB - my error

Regards

Mike
« Last Edit: January 09, 2019, 01:06:46 PM by madswitcher »


SIXTYNINER

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #30 on: January 09, 2019, 01:42:08 PM »
> Magic Man Of GroupDIY !!

Just Google "Studer FTP". No magic needed.

Done but at that moment google showed only  old original studer  links …. grrrrr  >:(
(also got a screenshot about but server do not let me upload , it say:  images folder full..)

Hi again,

To save you some time, the line driver card I was referring to can be found in the A80  Mk 1 Service manual

https://www.reeltoreel.nl/studer/Public/Products/Recording_Analog/A80VU_MkI/Manuals/A80VU_MkI_Serv.pdf

 on page 228.  The op amp I was referring to is denoted as A101 and the gain is about 24dB and not 34dB - my error

Regards

Mike

More thanks Mike !
« Last Edit: January 09, 2019, 06:09:48 PM by SIXTYNINER »
>>" 1 Picture say what billions words cannot "<< - >>"SMD Kill the DIY STAR"<<
Why in the  forum  if no share

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #31 on: January 09, 2019, 11:39:33 PM »
The op amp I was referring to is denoted as A101 and the gain is about 24dB and not 34dB - my error

if you need some let me know... I remade them as spare for my 289, clone from the 4th version, I just add extra smd pad for low profile tantalum.

Best
Zam

madswitcher

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #32 on: January 10, 2019, 09:58:48 AM »
Hi Zam

PM'd you about these.

Cheers

Mike


scott2000

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #34 on: January 15, 2019, 11:19:53 PM »
Just happened across this thread.....maybe some interesting bits in it???

https://groupdiy.com/index.php?topic=6892.0

abbey road d enfer

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #35 on: January 16, 2019, 01:22:37 AM »
Just happened across this thread.....maybe some interesting bits in it???

https://groupdiy.com/index.php?topic=6892.0
Yes, particularly the last bit:
"...but I couldn't imagine that the remanence and hysteresis, and other properties of the tape itself don't have a very significant effect on the reproduced sound."
Who's right or wrong is irrelevant. What matters is what's right or wrong.
Star ground is for electricians.

scott2000

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ?
« Reply #36 on: January 17, 2019, 12:25:50 AM »
Well there goes that......


fazer

Re: Studer Revox Any Diy Project-Kit Or Rev-Eng ? New
« Reply #37 on: January 21, 2019, 10:30:31 AM »
Studio I start in years ago had studer A80 mark 1 recorders.  24  tk, and two /2  tks.  I did manitence on them and loved the build, but a golden eared engineer I learned from always loved the sound of his mixes from a 1/2 track A77, at 15 ips .  He wanted me to modify one A80 with Revox cards.  Never happened but was always an issue.  The A 700 Revox was a beautiful transport but sound neutralize compared to an A77.  We like flattery over honesty.
« Last Edit: January 21, 2019, 11:03:09 AM by fazer »


 

Related Topics

  Subject / Started by Replies Last post
0 Replies
1271 Views
Last post October 15, 2008, 03:20:08 PM
by skal1
5 Replies
1359 Views
Last post April 15, 2010, 03:10:54 AM
by gswan
58 Replies
13277 Views
Last post June 05, 2014, 05:15:27 AM
by Luax
1 Replies
432 Views
Last post September 16, 2018, 04:20:49 PM
by TillM