REDDi parts specifications

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Quayhog

Well-known member
Joined
Oct 11, 2014
Messages
135
Location
Bay Area California
What are (did) builders using (use) for REDDi power transformers?  specs? or specific available USA voltage brands?  Would my spare tube mic power supply for Sterling/Groove tubes PSM-1 work.  it powers a mic using a 5840 (6204) pentode. Im not sure of the voltage.  It already has 6.3 vdc for heater.

I have one of CJ special wound output transformers and Im about to start  the project.
I do have a 250ct @25ma, 6.3@1a Stancor. Its an ideal physical size for my chassis but the HV is a bit high.

Jonathan
 
I'm doing a remote psu module for mine  ...  signal unit 2m away  ...  then with the fine tube and CJ output traffo

A Hammond psu traffo ...  60mA of HV and 2.5A of 6.3V heater,  I think  ...  is the smallest one I have ...  used it before in my la2a build. 

It's 'over specified' and using a small SS regulator pcb  ...  so I have it able to power up another tube signal module as well.

My build is more of a CJeddi  ..  with an extra tube too  (as well)    8)
 

Latest posts

Back
Top