Potato Cakes
Well-known member
Hello, everyone,
I am swapping out IC op amps and changing feedback resistor to adjust gain specific to my current project. I would like to know I would go about determining a corner frequency for the new op amp? I can figure out what this was for the original chip, but I don't know if there would be any problem basing this off of the original schematic.
Thanks!
Paul
I am swapping out IC op amps and changing feedback resistor to adjust gain specific to my current project. I would like to know I would go about determining a corner frequency for the new op amp? I can figure out what this was for the original chip, but I don't know if there would be any problem basing this off of the original schematic.
Thanks!
Paul