Budget Arb Gen gets 3rd party software
« on: September 26, 2019, 04:47:17 PM »
https://www.eevblog.com/forum/testgear/feeltech-fy6600-60mhz-2-ch-vco-function-arbitrary-waveform-signal-generator/2025/

Over there a  programmer has created a custom front panel UI for the Feeltech unit ,
The new code is  flashed to the display/control board memory with an St-link programmer ,                                                                                                                                 
The pc based program is connected via usb  and gives remote control of all functions on the front panel  plus adds a cal page  and allows compatible arb wave file upload .

I got stuck in and flashed one of my two units over to help pick up some of the bugs .


 

Related Topics

  Subject / Started by Replies Last post
17 Replies
6127 Views
Last post March 07, 2006, 02:59:20 AM
by mikep
7 Replies
1603 Views
Last post December 08, 2009, 04:53:12 PM
by mrclunk
64 Replies
11427 Views
Last post May 04, 2011, 12:44:32 PM
by peter purpose
3 Replies
1209 Views
Last post October 31, 2019, 12:52:29 PM
by [silent:arts]