dimebucker
Member
- Joined
- Aug 2, 2017
- Messages
- 10
Shure FP42 Stereo issue
- Thread starter dimebucker
- Start date
Help Support GroupDIY Audio Forum:
Bo Deadly
Well-known member
If you pan hard right in mono mode, does it still work as expected?
The answer to that will isolate the point-of-failure considerably.
The answer to that will isolate the point-of-failure considerably.
dimebucker
Member
- Joined
- Aug 2, 2017
- Messages
- 10
Hey, thanks for the reply 
I'm not near the unit now.. but I seem to remember that panning in mono mode has no effect/ works as expected.
I'm not near the unit now.. but I seem to remember that panning in mono mode has no effect/ works as expected.
dimebucker
Member
- Joined
- Aug 2, 2017
- Messages
- 10
squarewave said:
Ok I just checked, when I pan hard right in mono mode I get nothing. No output.
Bo Deadly
Well-known member
Then it's the mono / stereo switch. Look closely for a broken wire or bad solder joint. If it looks ok, squirt some Deoxit in there and move the switch back and fourth a lot. If that doesn't work and you don't want to try to source a new switch and you don't use the mic / line on that back, that's a two-pole switch.
