rascalseven
Well-known member
*** SOLD ***
-
If you have bought, sold or gained information from our Classifieds, please donate to Group DIY and give back.
You can become a Supporting Member which comes with a decal or just click here to donate.
FS: Coils Unlimited 600 ohm transformers *** SOLD ***
- Thread starter rascalseven
- Start date
Help Support GroupDIY Audio Forum:
ruffrecords
Well-known member
Can you tell me what are the dimensions of these transformers please. Also the primary inductance?
Cheers
Ian
Cheers
Ian
rascalseven
Well-known member
According to my Meterman 37XR multimeter (the only one I have that reads inductance) the windings measure as follows:
Pins 1 to 4 -- 352mH
Pins 3 to 6 -- 351mH
Pins 1 to 6 (pins 3 and 4 connected with jumper) -- 1.413H
Pins 7 to 9 -- 878mH
Pins 9 to 11 -- 878mH
Pins 7 to 11 -- 3.576H
[The last picture in the post above shows pinout]
Hope that helps! Thanks so much for asking.
JC
Pins 1 to 4 -- 352mH
Pins 3 to 6 -- 351mH
Pins 1 to 6 (pins 3 and 4 connected with jumper) -- 1.413H
Pins 7 to 9 -- 878mH
Pins 9 to 11 -- 878mH
Pins 7 to 11 -- 3.576H
[The last picture in the post above shows pinout]
Hope that helps! Thanks so much for asking.
JC
Hey Joel! Good to see you here.
Do you know what the lamination alloy is? 50/50? 80/20?
thanks man. Hope all's well!
Bryan
Do you know what the lamination alloy is? 50/50? 80/20?
thanks man. Hope all's well!
Bryan
rascalseven
Well-known member
Hi, Bryan.
No, I don't know what lamination material is, but the fella I got them from told me the laminations were special somehow... not a typical material, and in fact, most of the transformers made got scrapped (I guess the project they were made for didn't materialize?) specifically to reclaim the lamination alloy. I would love to know what it is, but I can't find any info.
They sound great though!
JC
No, I don't know what lamination material is, but the fella I got them from told me the laminations were special somehow... not a typical material, and in fact, most of the transformers made got scrapped (I guess the project they were made for didn't materialize?) specifically to reclaim the lamination alloy. I would love to know what it is, but I can't find any info.
They sound great though!
JC
I’m in for 4 if you have that many.
Will send a text and drive up to your place if that works.
Thanks!
Will send a text and drive up to your place if that works.
Thanks!
rascalseven
Well-known member
All gone. Thx.
JC
JC
