Sears Silvertone SE Output Transformer

« **on:** June 28, 2020, 11:54:33 PM »

this ACME OPT goes in the "amp in the case" rig and also the 1420 shock box>

« **Reply #1 on:** June 29, 2020, 12:05:19 AM »

spk leads out the top, HV out the bottom,

« **Reply #2 on:** June 29, 2020, 12:11:30 AM »

50 EI (1/2" tongue) 0.590 stack, 1 mil gap,

« **Reply #3 on:** June 29, 2020, 01:55:10 AM »

we had 3 samples, two had 73 turns on the sec and one had 75 turns, different enamel too.

red and dark red on the smaller 24 ga wire.

« **Reply #4 on:** June 29, 2020, 01:57:13 AM »

and here is the print>

« **Reply #5 on:** June 29, 2020, 01:59:38 AM »

um, sorry, little file management problem there,

print>

Subject / Started by	Replies	Last post
Output transformer needed for silvertone 1481 Started by mcfate The Lab	3 Replies 2315 Views	May 20, 2011, 02:01:35 AM by mcfate
Sears Silvertone 1472 Started by CJ The Lab	13 Replies 1365 Views	September 14, 2018, 09:46:08 PM by PRR
Sears Silvertone 1464 Amp Started by CJ The Lab	5 Replies 791 Views	October 27, 2018, 09:10:01 PM by CJ
Sears Silvertone 12AU6 Heater XFMR Started by CJ Magnetics	5 Replies 534 Views	November 15, 2019, 05:24:32 AM by CJ