Altec 9470

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

skeptic12

Well-known member
GDIY Supporter
Joined
May 28, 2012
Messages
126
Hi

Can anyone point me to the best way to attenuate signal in and/or out of Altec 9470?  I've gotten it powered and signal going in and out nicely, just not sure of best pads/attenuator scheme for it

thank in advance
 
The altec is not load critical.  Does fine at 10k, 100k, whatever.  The 1k is fine.  The Langevin is load critical, and 1k is probably fine there too.  Just not 10k. 
 
EmRR said:
The altec is not load critical.  Does fine at 10k, 100k, whatever.  The 1k is fine.  The Langevin is load critical, and 1k is probably fine there too.  Just not 10k.

Thanks Doug.

If had one 600r T PAd and a 1K pot which one would you use?
 

Latest posts

Back
Top