sonolink
Well-known member
Hi again everybody,
I've posted a few questions regarding this tube preamp pedal I've been working on for a while now, and I am almost finishing this project now (at last!!). It's coming out great thanks to all of the kind help I have had in this forum, and sounds huge.
I'd like to do a bass version, but without cabsim. My doubts are about the DI output. It should be like a parallel out that is "always on" for a soundcard or a mixer and you should be able to use either independently or both together.
1-Would the DI out section of the attached schem be correct?
2-I think I need to add protection caps in case someone leaves phantom power on at the mixer. 100uF/63v electrolytics would be ok?
3-Is it worth considering an output pot for the DI circuit? Is that "usual"?
4-Is 100k a correct value for R10 ?
Thanks a lot for your help
Cheers
Sono
I've posted a few questions regarding this tube preamp pedal I've been working on for a while now, and I am almost finishing this project now (at last!!). It's coming out great thanks to all of the kind help I have had in this forum, and sounds huge.
I'd like to do a bass version, but without cabsim. My doubts are about the DI output. It should be like a parallel out that is "always on" for a soundcard or a mixer and you should be able to use either independently or both together.
1-Would the DI out section of the attached schem be correct?
2-I think I need to add protection caps in case someone leaves phantom power on at the mixer. 100uF/63v electrolytics would be ok?
3-Is it worth considering an output pot for the DI circuit? Is that "usual"?
4-Is 100k a correct value for R10 ?
Thanks a lot for your help
Cheers
Sono