[KanonP]

Hello, I am an electronics newbie and I have been putting together an EZ1073 preamplifier and eq. I have everything cased up and my voltage measurements are 23.95 for 24 volts and I biased across r26 to 130mV. But my 48v measurement was 48.5. Then I plugged it in just know and I'm only receiving 49.2 volts. Every time I try to adjust the trim pot, it goes down very little and only to 49.` So I don't know if this is fine or I need to replace something? Anyway, thanks for reading my post.

[KanonP]

I got it to now, took another measurement, and getting 48 on the dot.

Feeler: an "Eee-Zzz" christmas present...ez1073 and ez1073-500

Started by Slenderchap « 1 2 ... 50 51 » Preamplifiers

help: ez1073-500 mic input clicks and pops

Started by mulletchuck The Lab

SWEEPS!!! LC53A vs EZ1073

Started by mulletchuck Filters/Equalizers

AML EZ1073 -> Urei 1176LN Rev. G - impedance problem, highpassed signal?

Started by SKJGProject The Lab