[ccal12]

Is there a way to convert a VU meter to display/work as peak level?

I have some VU meters with an internal impedance of 650 ohms
I have some Peak Level meters with an internal impedance of 1000 ohms

they both use a p-55 housing,
 however when hooked up to the isa 428,
the VU has a voltage drop of around -5.5VDC (pegs hard to the left)
and the Peak Level has a voltage drop of -0.05VDC (exactly where it needs to be)

[ccal12]

I figured it out,
Basically what i did was rewire and not use the board with a resistor in place, I'm going green to negative, and red to positive, I'll try to post up pictures. i don't believe its the most accurate but it might be pretty close.

Measuring peak to peak values without an oscilloscope?

Started by Sammas The Lab

Digital Audio Peak Level Meters

Started by laitue5 Brewery

KYORITSU KP-87B Peak Level Meter problem.

Started by pern The Lab

TOYO Type 67 Peak Level Meter

Started by L´Andratté Black Market