[catosalsa]

Setting up a conference system at my job and need help.

I have an amp called Advance Acoustic MAP-305:
Specs: Power output: 100 watts per channel into 8Ω (stereo)

And a bunch of speakers called JBSYSTEMS k-50 marked with 50 Watts RMS, 8 OHM

How many speakers can I have in parallell on each channel of this amp?

[aazaa]

hello,

it is possible to connect 4 speakers in series/parallel per channel.
look at:    http://www.regiscoyne.com/tech/spk_cab_wiring/

[catosalsa]

hello,

it is possible to connect 4 speakers in series/parallel per channel.
look at:    http://www.regiscoyne.com/tech/spk_cab_wiring/

Dont understand. If having 4 speakers on one channel the load will be 2Ohms, and the guide on your link says "Do not use a lower impedance load, as this could cause serious damage to your SS amp."

[aazaa]

Please look at "Series/Parallel Connections" in the page of the link.
It is giving the solution for your problem.

You'll see the picture below.

[catosalsa]

Please look at "Series/Parallel Connections" in the page of the link.
It is giving the solution for your problem.

You'll see the picture below.

Thanks! Now I see!
Do I have to be concerned about wattage? 4 x 50W speaker = 200W and I have an amp rated 100W?

[aazaa]

No worries about wattage. Just try it out. If the efficiency of your speakers is not very low, 2x 100w is sufficient for amplifying a conference system.

[scott2000]

Amp may be rated for more power at lower ohms? Could give some other options too perhaps?

DIY Guitar Amp Speaker Suggestions

Started by The Lab

Advice on paralleling a second speaker to guitar amp

Started by StephenGiles The Lab

Transformer balanced speaker output from amp

Started by dasbin The Lab

Tapping off speaker jack to feed input on larger amp

Started by idylldon Drawing Board