[dbonin]

Is there a standard or recommended test procedure for a stock Pultec EQ?


Thanks!
Don

[gyraf]

No.

Can you explain what you are really looking for?

/Jakob E.

[dbonin]

I guess I'm just looking for a logical approach to testing my latest build, which is an EQP1A. 
My first pass is not to validate the wide range of EQ settings, but to check some baseline performance metrics.

Something like this?

Input  a .775 volt, 1khz sine wave (preferably @600ohms)

Measure the output under the following conditions:

• Bypassed : output should be in the range of <value> volts with 1khz sine on output
• With <knobs> in <some> position output should be <volts>

[ruffrecords]

I guess I'm just looking for a logical approach to testing my latest build, which is an EQP1A. 
My first pass is not to validate the wide range of EQ settings, but to check some baseline performance metrics.

Something like this?

Input  a .775 volt, 1khz sine wave (preferably @600ohms)

Measure the output under the following conditions:

• Bypassed : output should be in the range of <value> volts with 1khz sine on output
• With <knobs> in <some> position output should be <volts>

A basic first test should be done with the EQ bypassed as this should establish if there is any overall gain and the baseline frequency response. The engage the EQ and keep the controls in the flat position and measure the frequency response again. it should be pretty much the same. You could also measure the distortion at various levels and frequencies to make sure the gain make up amp is behaving.

Cheers

ian

[EmRR]

Yes, EQ flat to confirm amp response.  Somewhere here I posted all the curves from an Analog Allstars EQP1S5 I have, they seem to match the published Pultec curves in the manual.  Have a look at that. 

[dbonin]

Thanks Ian, Doug.

some finished Pultec EQP1A - 'pimp my pultec'

Started by nrgrecording « 1 2 3 4 » The Lab

DOA Test procedure

Started by benlindell The Lab

Ua 175b test, operate, balancing procedure?

Started by wkbdgeorge The Lab

Discrete Opamp Stress Test - What's your procedure?

Started by elskardio Drawing Board