Oktava MK 319 help

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

wgtenor

Member
Joined
Jun 2, 2005
Messages
19
Location
Ky, USA
I wanted to do some tweaking on my Oktava mk319 and thought I would run my ideas by the guys here.

I am wanting to replace R1 and R2 with 1G ohm resistors for better response and C2 and C5 with the 1000pf polystyrenes. Also is Q1 the same fet as the MK-012? The areas of the two schematics look similar.

I had extra parts left over from my MK012 somewhat Dorsey mods and thought they might work on the MK319.
Any other suggestions are more than welcome.
 
there is much information on the subject here. do some searching on the mk-219 and the mk/c-012s and you'll see.

:thumb:
 

Latest posts

Back
Top