25 P&G faders

[hitchhiker]

25 P&G Faders , with Plessey connectors

These P&G faders are in very nice condition, lightly used and very smooth in feel, as you would expect from very good condition P&G's. I will supply the specs, measurements and pin outs.

25 of P&G 1520/AK35  long throw 600 ohm mono faders with matching cable connectors and attached face plates, all in very good condition.

$30 USD each, my asking price is what I paid.

TOTAL package comes to  $750 USD 

 

[hitchhiker]

P&G 1520/AK35 face plates measure,

190 mm  x 40 mm ,

screw holes on  176 mm  centers.

they are 104 mm  throw

 

[Spiritworks]

I have been toying with the idea of building a fader pack for my 500series side car. Is it possible to simply insert a fader like this in the direct outs or the line inputs of an API8200A?

 

[hitchhiker]

For the API 8200 outputs I would say yes,  no problem.

For the faders in line with the feed into the API8200 inputs it depends on the sound card or tape deck drive capability, some units may not have the beef to deal with a 600 ohm load.  For instance my RME Multiface and UA 2192's have no problem into a 600 ohm load.  What sources would you be mixing from?

 

[Spiritworks]

Currently using IZ RADAR for playback.

 

[hitchhiker]

Very nice,  I've always had the IZ RADAR high on my wish list.  I'd be very surprised if the RADAR would have a problem with driving a 600 ohm load.

 

[fragletrollet]

How would these do in place of 1k faders?

 

[hitchhiker]

I would say they would work well. If you post the schematic of the fader circuit in the drawing board you'd likely get some good answers with specific performance details.