4mm to 6mm Pot Shaft Adapter

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

zayance

Well-known member
GDIY Supporter
White Market Member
Joined
Feb 25, 2009
Messages
2,320
Location
France/Swiss
Hi Guys, well, i tried to custom make some with some drop offs of tiny brass tubing, adding two layers of different diameter, doing a cut on the lenght so for the set screw to tighten both the tubes, but the result is not that good, the pot doesn't turn very nicely, so i was wondering if such thing exists? Adapters for 4mm to 6mm Pot Shaft??
Or maybe some better trick?

Thanks a lot
 
Best trick is to turn them properly on the lathe. Does not have to be brass, a tight fit acetal will also do. Unfortunately I am going away on Friday and I don't have time but otherwise I could make some for you.
 
Best trick is to turn them properly on the lathe. Does not have to be brass, a tight fit acetal will also do. Unfortunately I am going away on Friday and I don't have time but otherwise I could make some for you.

No Problem, Thanks anyway for proposing, i'll stick with the Banzai solution, or change pots  :), i mean knobs  ::)
 
This should do the trick nicely... (and cheaper than Banzai)
http://www.selectronic.fr/article.asp?article_ref_entier=10.9176-20

Axel
 

Latest posts

Back
Top