Reply to thread

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

You might notice a difference if you flip the phase with the transformer on a steady signal of 400 hz, but when you play a guitar signal I don't think it will make much difference, try and see.


Since those springs have a delay time, your guitar signal phase will come out of the pan at different angles depending on what note you hit.


But I get wanting to avoid the 3.3 meg / 10 pf network. Almost all of your signal is going through that 10 of cap as Xc is only 40 k ohms compared to 3 meg.


Dang it I had the best sounding amp, it was an epiphone tube amp chassis with a diy circuit, I wanted to add reverb so j spliced something in there, the problem was that when you turned the reverb knob up, the gain went up, but there was a point there where the overdrive and the verb sounded awesome. So what do I do? Tear it out to try something different and I lose the magic tone and I fic not bother to write a schemo so the tonf is gone forever.


Back
Top