AKG C61 / N61A PSU SCHEMATICS?

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
thank you very much.

i replaced the dying stock cable with mogami w3172 tube mic cable using the original cannon connector and replacing the XLR 5 pin with a Neutrik. The pad switch was also quite dirty and crackling but a bit of deoxit fixed that. nice sounding mic!
 
As a side note: I have restored a few of these, and most of the time the original cable has been damaged near the Cannon RWK connector, making it microphonic; cutting the cable, say 10-20 cm shorter, and re-soldering the Cannon connector was usually enough to make it perfectly usable again. If the original cable wasn't abused much, that is. But I like to keep things as original as possible, which may sometimes be less practical.
 
Back
Top