balanced line level HP filter help

[penguin]

balanced line level HPF any schematic... check forum, there was one for LPF but link is dead

should i just use 2 separate passive HPF and connect it to hot and cold, or should i make it unbalanced first then HPF back to balanced again ???

i am gonna choose the cap value with trail and error, with measuring actual room response..

hot -----cap----+------- out
                     +res to gnd (180k)

cold-----cap-----+--------out
                      +res to gnd(180k)

gnd------------+connect to resisitors----- gnd


edit: i want to get 100hz roll_off from bigger speakers, close to ns10's

 

[penguin]

???

did  ask something stupid ???

all i need is a balanced passive HPF schematic,
for my soundcard output...

 

[pstamler]

I'm a little confused: what is the soundcard feeding? A differential tube stage?

Peace,
Paul

 

[Nora]

The resistor should go between + and -
There's a calculator on ethan's site

http://www.ethanwiner.com/gadgets.html

Do you need this for room mode corrections?
None of my business since you didn't ask but there are much better solutions than eq.

 

[penguin]

not for room correction...
just general purpose balanced passive HPF filter... i could use before my comp, (not as sidechain)
or output of my pre, or whatever line level signal.....


EDIT :  cheers for the link got it