jyrki3101
Active member
I just begun to build the 1176LN revD (rotary version) in a purusha's case. All the wiring diagram(s) I could find were for this pushbutton ver.
I use the UA-5002-1a REV B output transformer from Hairball. On some threads they say it's EA- 5002?...am I missing something.....
The transformer has also 2 EXtra wires( orange and yellow) Where do I connect them?
PSU wiring help would be also very much appreciated! What components to leave out from the main pcb when using mnats external psu board....
I read somewhere that attack pot should have a switch?Why?...and what kind of(part number? for mouser or....) How should I wire that pot w/switch
Skylars wiring diagram is also differend from what I see on mnats ratio/meter boards.
If there's a wiring guide for the version I'm buillding, I'd be very thankfull if someone could help with this!
With Kind Regards, Jyrki Telila
email: [email protected]
I use the UA-5002-1a REV B output transformer from Hairball. On some threads they say it's EA- 5002?...am I missing something.....
The transformer has also 2 EXtra wires( orange and yellow) Where do I connect them?
PSU wiring help would be also very much appreciated! What components to leave out from the main pcb when using mnats external psu board....
I read somewhere that attack pot should have a switch?Why?...and what kind of(part number? for mouser or....) How should I wire that pot w/switch
Skylars wiring diagram is also differend from what I see on mnats ratio/meter boards.
If there's a wiring guide for the version I'm buillding, I'd be very thankfull if someone could help with this!
With Kind Regards, Jyrki Telila
email: [email protected]
