skal1
Well-known member
drpat
i have already check R1 measures 2.25 Meg
as a side note i did find that if i removed R1 the oscillation stopped. if the c1 was bad would you see the effect in att mode, when in att mode their was know release is this due to r1 not being in Parallel with C1.
I will recheck with R5 full clockwise , and take reading ref to ground ..
Should the federal be on while taken the resistive readings.
I will post 2morrow
thanks again drpat
skal1
i have already check R1 measures 2.25 Meg
as a side note i did find that if i removed R1 the oscillation stopped. if the c1 was bad would you see the effect in att mode, when in att mode their was know release is this due to r1 not being in Parallel with C1.
I will recheck with R5 full clockwise , and take reading ref to ground ..
Should the federal be on while taken the resistive readings.
I will post 2morrow
thanks again drpat
skal1