dmp
Well-known member
Sounds really close -
Used the Xvive reissue MN3009.
The LFO is taken from a CE-2 and uses a rate pot, can go from about 0.3Hz to 3Hz. But at the slow end matches the frequency of I (0.4Hz) or II (0.6Hz) and although it can't match I+II exactly, it is pretty similar at the fast end.
Does not have the circuitry to filter the triangle wave or put the two LFO outputs in phase when both I&II are on. Maybe I can still add that in on a DPDT switch.
Used this PCB with a few mods.
Hammond enclosure with the DIY walnut ends (still need to sand, finish, and label) And I need to get a blue paint for the stripe, instead of the painter's tape lol
Used the Xvive reissue MN3009.
The LFO is taken from a CE-2 and uses a rate pot, can go from about 0.3Hz to 3Hz. But at the slow end matches the frequency of I (0.4Hz) or II (0.6Hz) and although it can't match I+II exactly, it is pretty similar at the fast end.
Does not have the circuitry to filter the triangle wave or put the two LFO outputs in phase when both I&II are on. Maybe I can still add that in on a DPDT switch.
Used this PCB with a few mods.
Hammond enclosure with the DIY walnut ends (still need to sand, finish, and label) And I need to get a blue paint for the stripe, instead of the painter's tape lol
Attachments
Last edited: