looking for a Pico se II front panel design

[plumsolly]

Building a Pico compressor and need a front panel.

Thanks,

Ben

 

[pyjaman]

Hi, I lost my datas in a computer crash but I had one in fpd format from Wayne from the Pico forum. As he is normaly the one who used to sell the boards, I'm sure he will be kind enough to provide it to you.
Good luck.
Laurent.

 

[radiance]

Since the pico has gone commercial (P3S) I don't think Wayne's going to share anything pico related.

Is there any special reason for you not being able to make one yourself?

 

[ilfungo]

sorry guys
I am going to buy 2 mono channels of the Pico Compressor
Where can I find info for :
PSU?
Wiring?
Meter?
Thanks!

 

[pyjaman]

Hi,
Any common simple +/-15v psu such as JLM ACDC or the like will work.
Have you asked the seller about wiring and metering documentation ? he might have had it when he bought the boards to Wayne, otherwise, It would be worth a try to contact Wayne or Roger, as those boards where provided by them when Roger shared this project . Even if it became a commercial product,  many of these DIY projects were finished after it did , and the gentlemen didn't stop supporting them totally.
And sharing a switch wiring diagram or a FPD file is not like sharing a complete schematic.
And anyway, no one will bite you. Even if there is no support any more.
Just my two cents.

@ Plumsolly : PM'd you.

Laurent.

 

[ilfungo]

Thanks pyjaman
I wait the seller  that  sends he the documentations....
THANKS