mic sticky? head amp calibration?

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

shabtek

Well-known member
Joined
Jun 8, 2005
Messages
2,375
Location
midwest usa
I am looking for a proper procedure to check response of capsule impedance converter/head amp.
I know it comes up in many build threads.
    feed grid/gate but through what and from what? what is ideal termination etc.?


should there be or is there a thread to cover all these basics for mic building?
response testing, defluxing/conformal coating noise abatement, etc
 
shabtek said:
I am looking for a proper procedure to check response of capsule impedance converter/head amp.
The usual procedure is to inject signal via a capacitor of value similar to the used capsule.
However it's not always possible, e.g. where NFB is applied to the "passive" electrode, as in U67/87. Then the mfgr has implemented a way to inject signal.

should there be or is there a thread to cover all these basics for mic building?
response testing, defluxing/conformal coating noise abatement, etc
I think it could start as a thread in The Chamber...
 

Latest posts

Back
Top