Need help with EZ1073.

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

KanonP

Member
Joined
Oct 9, 2019
Messages
21
Hello, I am an electronics newbie and I have been putting together an EZ1073 preamplifier and eq. I have everything cased up and my voltage measurements are 23.95 for 24 volts and I biased across r26 to 130mV. But my 48v measurement was 48.5. Then I plugged it in just know and I'm only receiving 49.2 volts. Every time I try to adjust the trim pot, it goes down very little and only to 49.` So I don't know if this is fine or I need to replace something? Anyway, thanks for reading my post.
 
Back
Top