Reply to thread

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message

I assume you mean it’s not attached to the board as it sure looks like it’s soldered to pin 2 of the tube socket. This is G2 of the tube which in the schematic shows being connected to the side of C1 that is not attached to the backplate of the diaphragm, this is the junction of C1 R2

[QUOTE="RoadrunnerOZ, post: 1099114, member: 136533"] I assume you mean it’s not attached to the board as it sure looks like it’s soldered to pin 2 of the tube socket. This is G2 of the tube which in the schematic shows being connected to the side of C1 that is [B][I]not[/I][/B] attached to the backplate of the diaphragm, this is the junction of C1 R2 [/QUOTE]

Verification

General Discussions
The Lab
Noob needs help with z5600a II mic repair