babyhead
Well-known member
I have some circa 1979 transformerless channel strips I am planning on recapping. All of the psu and phantom blocking caps are axial so my choices are limited. I'm willing to stick almost any 220uf/40v above a Xicon in there as I have 70 of these to replace, but I would think the phantom blocking caps should deserve special attention.
Does anyone have any experience with different caps here?
Can I just jumper them if I never use phantom on the strips? The design calls for it to always be on...
I also have to make a psu that will cover +/- 32v and +/- 28v. I have a Power One that can handle the 12v logic but it's kind of hard to find any stock psu to handle those voltages. I'm looking at the 51x psu for my solution. Any thoughts?
Mark
Does anyone have any experience with different caps here?
Can I just jumper them if I never use phantom on the strips? The design calls for it to always be on...
I also have to make a psu that will cover +/- 32v and +/- 28v. I have a Power One that can handle the 12v logic but it's kind of hard to find any stock psu to handle those voltages. I'm looking at the 51x psu for my solution. Any thoughts?
Mark