I have recently built a G7. It is hum free and sounds very good, but in a totally wrong way:
In omni position the audio signal is very weak, but when I tap the microphone it is very much alive.
In cardioid it works, but the backside is the active one!
In fig-8 the signal gets stronger and it is kind of fiig-eightish, but the back side is the dominant side.
The PSU gives perfect values.
The variable patterns to the back should read 0-80-160 volts in omni, cardioid and fig-8, but the values I get is 0-15-30 volts measured between back and front. Center seems to be dead with none or very small values.
If anybody out there could help me I would lose ten tons of wight. This is so frustrating!
pbirk
In omni position the audio signal is very weak, but when I tap the microphone it is very much alive.
In cardioid it works, but the backside is the active one!
In fig-8 the signal gets stronger and it is kind of fiig-eightish, but the back side is the dominant side.
The PSU gives perfect values.
The variable patterns to the back should read 0-80-160 volts in omni, cardioid and fig-8, but the values I get is 0-15-30 volts measured between back and front. Center seems to be dead with none or very small values.
If anybody out there could help me I would lose ten tons of wight. This is so frustrating!
pbirk