Siegfried Meier
Well-known member
Hey all!
I’m struggling to decide on how best to get from our Magnum buss outs (which are all unbalanced) into the 16 pin IDC of the JLM Tardigrade balancers.
The Magnum buss outs terminate on an EDAC connector and initially I considered a short cable from EDAC out to the JLM board in, but can’t seem to figure out a clean way to get into a 16 pin IDC connector…
Any thoughts much appreciated!
Thanks,
Sig
I’m struggling to decide on how best to get from our Magnum buss outs (which are all unbalanced) into the 16 pin IDC of the JLM Tardigrade balancers.
The Magnum buss outs terminate on an EDAC connector and initially I considered a short cable from EDAC out to the JLM board in, but can’t seem to figure out a clean way to get into a 16 pin IDC connector…
Any thoughts much appreciated!
Thanks,
Sig