enthalpystudios
Well-known member
hey guys... have there been any (successful/established, i guess) tube mic pre circuits that are balanced throughout, as in separate amplification for side of the signal? Is this worthless/overthetop/ridiculous?
I guess tube doesnt necessarily matter. But I'm just wondering if anything is ever designed essentially like a stereo unit, but where pin 2 goes to one side, and pin 3 goes to the other, CMR never takes place, and it counts on a later stage to perform CMR.
All things being more or less matched, wouldn't it drop the noise of the entire stage as low as the CMRR of the following stage will allow?
I guess even a stereo unit could do this, if used unbalanced. Maybe i can just finish this g9 and this NYD 1bottle and try it out for myself. Just wondering if its been done much.
billy
I guess tube doesnt necessarily matter. But I'm just wondering if anything is ever designed essentially like a stereo unit, but where pin 2 goes to one side, and pin 3 goes to the other, CMR never takes place, and it counts on a later stage to perform CMR.
All things being more or less matched, wouldn't it drop the noise of the entire stage as low as the CMRR of the following stage will allow?
I guess even a stereo unit could do this, if used unbalanced. Maybe i can just finish this g9 and this NYD 1bottle and try it out for myself. Just wondering if its been done much.
billy