A few months ago I decided to start fixing an old microphone I had laying around. After asking in this forum I chose the primo EM200 capsule to replace the old one. I have been quite busy in the meantime and I just started having a little more time to dedicate to the project. I've started trying to convert this schoeps schematic kindly provided to me by @kingkorg into a pcb schematic that I can send to an etching service. However, after trying some tools like Altium CircuitMaker and Fusion360 they all seem to be lacking most of the components required, and importing said components is proving to be a pain.
I was wondering if you all had any recommendations as far as design tools go.
Thanks in advance,
Tom
I was wondering if you all had any recommendations as far as design tools go.
Thanks in advance,
Tom