Walrus
Well-known member
There is a little pcb with a resistor on that you plug in to replace the wiring to the head (forgotten the correct name for that)
to adjust the 200 C set point.
Can't remember the resistor value, it's been nearly 20 years since I last calibrated a SAL75/VMS80 cutting system.
I hepled look after 3 systems at Sony Music Studios, London.
to adjust the 200 C set point.
Can't remember the resistor value, it's been nearly 20 years since I last calibrated a SAL75/VMS80 cutting system.
I hepled look after 3 systems at Sony Music Studios, London.