DOA running off single 24V Supply

[a soBer Newt]

Is it possible to run a 2520DOA off a single 24V supply as long as I bias the input to 12V? Would the ground pin of the 2520 get tied to 12V too?

 

[RSRecords]

I ran a 312 off of a single 36v supply. Talked about it in another thread. Basically just have to create a virtual ground with resistors between voltage rails and common. Then tie everything to that. Couple the virtual ground to real ground via a cap. 312 Preamp on single supply

 

[a soBer Newt]

I ran a 312 off of a single 36v supply. Talked about it in another thread. Basically just have to create a virtual ground with resistors between voltage rails and common. Then tie everything to that. Couple the virtual ground to real ground via a cap. 312 Preamp on single supply

Thanks for the link!