chriss
Well-known member
Hello forum,
I am about to rewire my whole studio and got a couple of questions:
1. The cable I'm using is 10-in-1 Multicore and the single wires are color-coded (grey, pink, brown, purple, black, red, green, blue, yellow, orange) , the second one is always white. Is there any kind of standard for the wiring-order of these? I would bet there is, since it's from german broadcast....
2. For the wiring of the patchbay: The manual says, the earth shall be connected to the outputs of all units only. o.k. And the racks shall be connected to the star-earth-point inside the mixer. But the cables are connected to the pacthbay via 2-pin molex-connectors (it's a Soundcraft TS-24). So for the output-connectors at the pacthbay: Do I collect the output-earth's inside of the racks and put them all together and from here to the star-earth?. And where to connect the input-earth? I'm a bit confused about all this...
thanks in advance
Chris
I am about to rewire my whole studio and got a couple of questions:
1. The cable I'm using is 10-in-1 Multicore and the single wires are color-coded (grey, pink, brown, purple, black, red, green, blue, yellow, orange) , the second one is always white. Is there any kind of standard for the wiring-order of these? I would bet there is, since it's from german broadcast....
2. For the wiring of the patchbay: The manual says, the earth shall be connected to the outputs of all units only. o.k. And the racks shall be connected to the star-earth-point inside the mixer. But the cables are connected to the pacthbay via 2-pin molex-connectors (it's a Soundcraft TS-24). So for the output-connectors at the pacthbay: Do I collect the output-earth's inside of the racks and put them all together and from here to the star-earth?. And where to connect the input-earth? I'm a bit confused about all this...
thanks in advance
Chris