saxmonster
Well-known member
- Joined
- Jan 3, 2012
- Messages
- 534
Ok, So i got 2 pcbs from a member on here.
I am going to build a rig for testing outside the rack. I am getting an sb4001 kit from someone who did not build theirs. I just wanna make sure my thinking is correct so I don't blow anything up. I wanna build a dual rig for the double card modules and also of course single card modules.
Here are the 2 pcbs, see pic below.
If I build a new 7-core 51x psu cable to come out of the 51x power supply to the 1st pcb can i then run another 7core wire from that 1st pcb to the second one?
I won't need any caps or resistors to change the power at all correct? Its basically just like the pcb already in the rack.
Are these the Xlr Connectors to use?
http://www.mouser.com/Search/ProductDetail.aspx?R=NC3MBVvirtualkey56810000virtualkey568-NC3MBV
http://www.mouser.com/Search/ProductDetail.aspx?R=NC3FBV1virtualkey56810000virtualkey568-NC3FBV-1
Of course I will get the 7core wire, headers / shunts and also the 36 card edge connectors from Jeff.
What size heat shrink should I get for the 7core wires when attaching to the new 7pin female cable mount.
Still a newbie at this stuff.
TIA
-Scott
I am going to build a rig for testing outside the rack. I am getting an sb4001 kit from someone who did not build theirs. I just wanna make sure my thinking is correct so I don't blow anything up. I wanna build a dual rig for the double card modules and also of course single card modules.
Here are the 2 pcbs, see pic below.
If I build a new 7-core 51x psu cable to come out of the 51x power supply to the 1st pcb can i then run another 7core wire from that 1st pcb to the second one?
I won't need any caps or resistors to change the power at all correct? Its basically just like the pcb already in the rack.
Are these the Xlr Connectors to use?
http://www.mouser.com/Search/ProductDetail.aspx?R=NC3MBVvirtualkey56810000virtualkey568-NC3MBV
http://www.mouser.com/Search/ProductDetail.aspx?R=NC3FBV1virtualkey56810000virtualkey568-NC3FBV-1
Of course I will get the 7core wire, headers / shunts and also the 36 card edge connectors from Jeff.
What size heat shrink should I get for the 7core wires when attaching to the new 7pin female cable mount.
Still a newbie at this stuff.
TIA
-Scott