buschfsu
Well-known member
hello,
i am getting ready to build a fetboy with fabios pcb. he used an oep input transfo but i already have a 15095a altec that i think scott recommended in the original hamptone design (on his site, not in the article). so, are there any recommendations on pinout or RL for that design? anyone using this? I also have a 15356 line xformer to use as the output iron. do i need to modify the design to use this?
thanks
ill post the results. im gonna have this and a baby animal in a 1 u rack, i can't wait to hear them.
oh yeah i have a 48v power supply that runs the baby animal and phantom so would it be ok to use a voltage divider using 2 120R resistors to cut the 48v down to 24? carbon resistors ok? if the jlm power is clean should i regulate after the divider?
thanks thanks thanks :guinness: :guinness: :guinness:
i am getting ready to build a fetboy with fabios pcb. he used an oep input transfo but i already have a 15095a altec that i think scott recommended in the original hamptone design (on his site, not in the article). so, are there any recommendations on pinout or RL for that design? anyone using this? I also have a 15356 line xformer to use as the output iron. do i need to modify the design to use this?
thanks
ill post the results. im gonna have this and a baby animal in a 1 u rack, i can't wait to hear them.
oh yeah i have a 48v power supply that runs the baby animal and phantom so would it be ok to use a voltage divider using 2 120R resistors to cut the 48v down to 24? carbon resistors ok? if the jlm power is clean should i regulate after the divider?
thanks thanks thanks :guinness: :guinness: :guinness: