Current Draw and operating voltages of Group DIY Projects?

Forgive me for being thick
But I can't see and don;t have the ability to work out the current draw and voltage of each of the Group DIY projects...
Note - without Phantom Power where applicable and not including the PSUs


1176

SSL

LA4

project 1 - neve

project 2 - api

green mic

LA2a

Pulteq

many thanks
working out how many PSUs to get

A Neve 1272-ish mic preamp draws around 200mA @ 24V. Phantom power is usually very low current.

The SSL runs of +/- 12V and 15V, not sure about the current.

HTH

Ian

I think I already gave figures on the Green and the KDMP on the Group DIY web pages.

As for my LA4 variant, I don't have a measured figure because the power trafo is on board with no convenient place to break the flow. Just count up the IC's and that will give you an idea.

Does it matter ?? These small power trafos will be fine.
If you do multiples then a 30VA will probably get you by most jobs that are IC based.

Lighting of meters etc can be an issue so don't forget about them.

Que...Meester Fawlty? 30VA .....please explain for a humble Englishman!
Stephen

Actually I tend to power pretty well everything I build from 2 12v motorbike batteries - much safer!
Stephen

VA=volts times amps. I guess another way of saying watts. Maybe a maximum of 30 volts?
30 volts at 1 amp, +/-15 volts at 1 amp, 15 volts at 2 amps all qualify. I don't know if 60 volts at 500ma does.