codered
Well-known member
Suppose I have a pot with 320 degrees sweep & say it needs to show 4kHz to 10Khz(by design) on the dial,how do I go about marking the dial.Somebody have an ready excel sheet or sumthin that can be used.
Another Q:when you guys buy premade cases or Front Panels how does the marking on the FP match your pot?if all pots/switches dont have the same angular travel then how would it match up (expecially for EQs)
Another Q:when you guys buy premade cases or Front Panels how does the marking on the FP match your pot?if all pots/switches dont have the same angular travel then how would it match up (expecially for EQs)
