pearldrum944
Active member
- Joined
- Dec 25, 2009
- Messages
- 41
Don't get me wrong, I want big knobs....but I'm wondering if maybe these are just a little too large. I'm building a 1u GSSL.
These knobs have a lower diameter of .710 in inches, the diameter with the point is 1.09 inches.
http://www.newark.com/grayhill/11k5028-kcnb/knob/dp/11C3976
According to my math, this gives me about .14 inches from the longest edge of the knob to the top of the rack unit. Is this enough distance?
I definitely want lettering printed...I think this will be fine if I let the knob cover whatever digit it is selected to. Does this look bad?
Thanks.
These knobs have a lower diameter of .710 in inches, the diameter with the point is 1.09 inches.
http://www.newark.com/grayhill/11k5028-kcnb/knob/dp/11C3976
According to my math, this gives me about .14 inches from the longest edge of the knob to the top of the rack unit. Is this enough distance?
I definitely want lettering printed...I think this will be fine if I let the knob cover whatever digit it is selected to. Does this look bad?
Thanks.